Brembo 18-20 Audi RS3 Front Dual Cast Rotor is the exact Brembo OE brake rotor identified by manufacturer part number BRE09.D939.11. Confirm the exact manufacturer part number and all current specifications before ordering.

Key Features

• Exact Brembo OE manufacturer part number BRE09.D939.11
• Product type: Brake Rotors
• Manufacturer application data takes priority over visual similarity

Fitment

Use the verified year, make, and model table below, then confirm the engine, drivetrain, body configuration, factory equipment, and every current manufacturer application note.

Specifications

What’s Included

One new Brembo OE brake rotor identified by manufacturer part number BRE09.D939.11 in the configuration shown. Hardware or companion parts are included only when expressly stated by the manufacturer.

About Brembo OE

Brembo OE manufactures automotive performance and replacement parts identified by exact part number, specifications, and published application data.

Related Brembo OE Products

• Shop all Brembo OE products
• Brembo OE Front Disc Brake Kit
• Brembo OE Front Disc Brake Kit
• Brembo OE Rear Disc Brake Kit

Frequently Asked Questions

How do I confirm BRE09.D939.11 is correct?
Use the verified year, make, and model table below, then confirm the engine, drivetrain, body configuration, factory equipment, and every current manufacturer application note.

Are similar-looking parts interchangeable?
No. Match part number BRE09.D939.11, dimensions, configuration, included components, and every current manufacturer note.

What is included with this listing?
One new Brembo OE brake rotor identified by manufacturer part number BRE09.D939.11 in the configuration shown. Hardware or companion parts are included only when expressly stated by the manufacturer.

Installation

Follow the current Brembo OE instructions for part number BRE09.D939.11. Verify fit, clearance, system specifications, fastener torque, and safe operation before use. Professional installation is recommended when specialized tools, alignment, calibration, or fabrication are required.