09-13 Toyota Corolla Rear Right Bumper Cover Support Bracket

Direct replacement rear right bracket engineered to support your OEM or aftermarket bumper cover. This hard panel construction component restores structural integrity at the bumper mounting point, critical for proper alignment and durability. Bolt directly into factory locationsno modification required.

Factory Mounting Points Direct-from-Warehouse In-House Quality Check

Key Features

• Factory mounting geometry – Aligns perfectly with OEM hole spacing, eliminating fitment guesswork
• Right-side application – Specific to passenger-side rear, exact counterpart to OEM
• Direct bolt-in design – Uses existing anchor points, no drilling or fabrication needed

Specs

• Hard panel construction
• Right rear bumper support bracket
• Single piece

Whats Included

• Rear right bumper cover support bracket

Frequently Asked Questions

Do I need fasteners to mount this bracket?

You’ll bolt it to factory anchor points using existing holes. Bring standard hand tools and your vehicle’s service manual for torque specsfasteners are not included with this bracket.

Will this work with an aftermarket bumper cover?

Yes. As long as the aftermarket cover uses standard OEM mounting geometry, this bracket will support it the same way it supports factory bumpers. Test-fit before final installation if you’re running non-standard hardware.

What condition is this bracket in?

It arrives ready to installno prep, priming, or painting needed before mounting. If you’re doing body work around the bumper, you can paint it to match your car after it’s bolted on.