93-98 Jeep Grand Cherokee Rear Bumper Reinforcement Bar

Bolt-on rear reinforcement that adds structural support where it counts most. This hard panel construction bar mounts to factory anchor points and absorbs impact energy without requiring welding or cutting. Built to handle low-speed contact and everyday parking lot reality.

Factory Mounting Points Direct-from-Warehouse In-House Quality Check

Key Features

• Factory bolt-on design – No welding, cutting, or frame modification needed
• Direct rear impact protection – Shields bumper assembly and frame from low-speed damage
• Straightforward installation – Uses existing anchor points for secure fitment

Specs

• Material: Hard panel construction
• Configuration: Single-piece reinforcement bar
• Condition: New

What’s Included

• Rear bumper reinforcement bar assembly

Frequently Asked Questions

Does this mount at the factory bumper attachment points?

Yes. This bar uses the factory anchor points no drilling or frame modification required. Test-fit before final tightening to confirm alignment with your specific vehicle.

Will this interfere with a trailer hitch?

Mounting method and clearance specs are not confirmed. Verify hitch placement and this bar’s position before installation to avoid any contact or conflict.

What prep work do I need to do before installing?

Clean the mounting surfaces and factory anchor points. Have basic hand tools and a torque wrench ready. Refer to your vehicle’s service manual for proper fastener torque specifications.