97-04 Chevrolet Corvette Front Bumper Reinforcement Bar

Direct structural support for front-end impact protection. This reinforcement bar bolsters your bumper assembly where it matters most. Hard panel construction designed to work with factory mounting architecture.

Factory Mounting Points Direct-from-Warehouse In-House Quality Check

Key Features

• Direct bolt-in design – Aligns with existing factory hardpoints, no drilling or modification required
• Impact-rated construction – Engineered to support bumper under load and minor contact
• OEM-spec geometry – Maintains proper fitment with existing front-end components

Specs

• Hard panel construction
• Designed for direct mounting to factory attachment points

Whats Included

• Reinforcement bar assembly

Frequently Asked Questions

Will this work with an aftermarket bumper cover?

This bar mounts to factory hardpoints underneath. Aftermarket covers that use the same mounting structure will work fine just verify your bumper cover attaches at the OEM mounting locations before ordering.

Do I need to remove the bumper to install this?

Yes. You’ll need to take off the front bumper assembly to access the mounting points. It’s a bolt-in install once the bumper is out of the way.

Can I paint this before installation?

You can, but it’s easier to do it after. Mask off the mounting points and bolt it on first, then sand and paint as needed. That way you won’t compromise any fitment during the painting process.