This aFe suspension component is the CONTROL 24-26 Toyota Tacoma 2-Way Adjustable Rear Sway Bar for 2024-2026 Toyota Tacoma. Verify drivetrain, trim, ride-height range, bar or spring rate, mounting points, wheel and tire clearance, alignment needs, and intended street or off-road use.

Key Features

• Application-specific handling or ride-height configuration
• Mounting, alignment, clearance, rate, adjustment, and intended-use requirements are model specific
• End Body Roll in Your Tacoma Without Giving Up Ride Quality The aFe CONTROL rear sway bar 440-72T006RR is engineered specifically for the 2024 to 2026 Toyota Tacoma N400 with the L4-2.4L turbocharged engine, including
• Manufactured from CNC-bent alloy steel and finished in a durable red powder coat, the 440-72T006RR delivers 2-way adjustable roll stiffness for precise on-road handling tuning.

Fitment

Specifications

What’s Included

One new aFe sway bar in the exact configuration and quantity identified by this listing. Hardware, clamps, couplers, gaskets, sensors, wiring, fluids, calibration, and accessories are included only when expressly stated.

About aFe Power

aFe Power develops application-specific intake, filtration, exhaust, cooling, tuning, suspension, drivetrain, and truck-performance components supported by product testing and documented installation requirements.

Important Disclosures

• California Proposition 65 warning: this product can expose you to chemicals known to the State of California to cause cancer and reproductive harm.

Related Parts

• aFe Control Sway Bar Set Johnny OConnell 97-13 Chevy Corvette C5/C6
• aFe Control PFADT Series Sway Bar Set; Chevrolet Corvette (C7) 14-15
• Shop the complete aFe Power collection

Frequently Asked Questions

Will the CONTROL 24-26 Toyota Tacoma 2-Way Adjustable Rear Sway Bar fit my suspension configuration (aFe 440-72T006RR)?
Match drivetrain, trim, factory suspension, ride height, wheel and tire package, and any exclusions shown for this exact product.

Will an alignment be required?
An alignment is recommended whenever ride height or suspension geometry changes and may also be needed after replacing bars, arms, links, or mounts.

Does the kit change ride quality?
Ride and handling depend on rates, adjustment, bushings, tire setup, and installation. Use the settings recommended for the intended street or off-road use.

Should fasteners be rechecked after installation?
Yes. Torque fasteners at the specified suspension position, inspect clearance, and recheck hardware after the initial driving cycle.

Installation Instructions

1. Confirm aFe part number 440-72T006RR, the complete vehicle or specification-based application, and all required supporting components.
2. Support the vehicle at approved points, record ride height and alignment condition, and compare every mount and component before disassembly.
3. Install hardware in the documented orientation and torque sequence, tightening pivot bushings at the specified ride position where required.
4. Verify full steering and suspension travel, wheel and tire clearance, alignment, and fastener torque before normal driving.